From JeepTech and JeepTech Publishing LLC, the Jeep knowledge base. |
| All text is available under the terms of the GNU Free Documentation License. |
The "Super Hurricane" 226 L-Head engine has a cast iron block and cylinder head with 4 main bearings and solid lifters. The exhaust and intake valves are in the block, not in the cylinder head. The engine was used in earlier Willys cars, but was first introduced in 1950 in Willys trucks. The Willys Pickup and Willys Wagon used the 226 from '54 until '63. There was an option 7.3:1 high altitude version available during these years.
The 226 used between 1954-1958 has a slightly higher horse power rating than the later 226. Note that the Bore and Stroke specs do not add up to the proper displacement !!
| Super Hurricane L-Head 226 I6 | |
|---|---|
| Bore x Stroke | 3.94" x 4.375" |
| Displacement | 226.2 Cubic Inches |
| Compression Ratio | 6.861:1 |
| Horsepower (gross) | 115@3800rpm |
| Torque (gross) | 190@1800 |
| Main Bearings | 4 |
| Valve Configuration | L-head |
| Fuel | 1-bbl Carter |
The 226 used from 1959-1962 has a slightly lower horsepower rating, but the torque peak comes at a lower RPM.
| Super Hurricane L-Head 226 I6 | |
|---|---|
| Bore x Stroke | 3.94" x 4.375" |
| Displacement | 226.2 Cubic Inches |
| Compression Ratio | 6.861:1 |
| Horsepower (gross) | 105@3600rpm |
| Torque (gross) | 190@1400 |
| Main Bearings | 4 |
| Valve Configuration | L-head |
| Fuel | 1-bbl Carter |
