Jeepfan.com
serving the Jeep community since 1997
QUESTION: I have a 1983 CJ-7 with a 258 six. It has a T-5 five speed transmission with (I believe) a Dana 300 transfer case. The transmission blew apart and I need to change it out. Do I have to change the transfer case too or will the Dana 300 bolt up to a Jeep …
There is not much that is factory on this thing…the hood, fenders and grille? Under the hood is an AMC 401 backed with a TH400 automatic, behind that is an Atlas. The rear Ford 9″ axle contains a spool while the front is a Cherokee Dana 44. The Jeep features a custom race suspension and …
This Jeep is going to be awesome when it’s done. A wild quarter mile ride! See below.
Keeping up with the Jones’. Total restoration of a 1984 CJ-7 from rust to fiberglass, new engine, and more.
New Information – After two years of driving with the T-18 I am still pleased, one problem I have had is a clutch binding issue. I determined that the problem was in the bell housing and would not be easy to fix due to the transmission being extremely heavy and cumbersome to remove. I have …
After several trail runs with my 78 CJ-5 equipped with a T-150 3 speed trans it became obvious that a gear change was essential. My CJ has 3.54 rears, a Dana 20 transfer case (2:1 low range), and low a gear in the T-150 that is only 2.99:1. This equates to approximately 21:1, this is …
