Jeepfan.com
serving the Jeep community since 1997
Continuing on from page 2. Now that the front part of the kit is installed the rear section can be installed and tied into the forward center section. If your Jeep has door surrounds you can try to test fit and trim as needed. Ours required quite a bit of trimming in the front part. …
Continuing on from page 1 you would be at the point of having all the padding, covering and door surrounds out of the way. Following the supplied directions the installation starts with the front section, door uprights and dash cross bar. Don’t tighten up anything until everything is installed. We used a small piece of …
The TJ factory bar is probably sufficient to provide protection in an accident but there’s definitely room for improvement. The forward part of the bar is simply attached to the windshield which isn’t going to offer much resistance when the weight of the Jeep is applied. Now, one could have a professionally created, welded in …
