BDS 3″ Lift for Wrangler JK Rubicon – Part 3
Install the front springs with the spacer inside the spring. Using the fasteners provided attach the bump stop spacers to the spring pad.
Projects & Installs
BDS 3″ Lift for Wrangler JK Rubicon – Part 2
As with all projects we write about here at jeepfan.com safety is a top priority. Make sure the Jeep is properly secured when supported by something other than on all fours. Use properly rated jack stands. Also, these articles may not lift all the small details involved in an install. Make sure you are capable …
BDS 3″ Lift for Wrangler JK Rubicon
In the early stages of the jeepfan.com JK we installed a 2.5″ Tera Flex Budget Boost lift kit. The kit has served the Jeep well in the year it was installed but it has come time to upgrade to a “real” lift that includes shocks, springs, etc.
CoolTech Wrangler JK CB Antenna Mount
A clever CB antenna mount that hides in the JK license plate mount.
Poweraid Throttle Spacer and Airaid Cold Air Intake install – Part 2
Installation Steps and Tips Continued After removing the temp sensor continue by removing the four bolts in the throttle body and pull the throttle body out. Install the spacer then the gasket then using the supplied bolts reinstall the throttle body.
Poweraid Throttle Spacer and Airaid Cold Air Intake install
Adding a little more oomph and some extra MPG to Christine’s JK. Having a nice new lift, new tires and wheels, and some other mods Christine’s JK needed some extras under the hood to help the performance and efficiency of the 3.8L V6.
Mopar Rock Rails for Wrangler JK
Adding some side armor to Christine’s JK After dragging her Sahara’s steps over the rocks at Rausch Creek Off Road park Christine decided an upgrade was needed to prevent expensive body damage to her 2007 JK.
AEV JK Wrangler Front Bumper Install – Part 3
Bumper Installation Install the winch mount making sure you place the 3/8″ plates between the mount and the frame. Follow the directions for proper tightening and spacing. Place the winch into the mount. TIP: Do not bolt in the winch at this time. You will need to slide the winch side to side to get …
AEV JK Wrangler Front Bumper Install – Part 2
Remove the old stuff Start by removing the factory plastic skid plate then bumper followed by the plastic closeout on top of the frame. TIP: Be sure to disconnect the fog lights and detach the wiring harness from the inside of the bumper.
AEV JK Wrangler Front Bumper Install
About the bumper Without a doubt the new JK Wrangler front bumper from AEV has to be the most stylish and functional bumper available today. In usual AEV fashion this new bumper matches the modernized design of the new Wrangler. The unique quality of the bumper is it’s stamped design that allows the bumper to …